Technogym Personal Selection TUV - Selector Switch for Additional Weight; Machines with Cross with Crimped Cable Fitting

Personal Selection TÜV: Service & Maintenance Manual - rev. 1.0
Page 6.13
6.8. SELECTOR SWITCH FOR ADDITIONAL WEIGHT
This operation does not apply to Leg Press, Low Row.
The selector switch for additional weight is hooked onto the cross. Since there are only 2
mechanical solutions available:
• cross with crimped cable;
• cross with doubling pulley.
there are 2 different disassembly procedures detailed here below:
6.8.1. MACHINES WITH CROSS WITH CRIMPED CABLE FITTING
This operation applies to Abdominal Crunch, Leg Curl, Leg Extension, Lower Back,.
Photo 6.8-1
1. Loosen the counter-nut a using a 22-gauge
wrench.
2. Unscrew the screw b at the end of the cable
so that the cable is free.
Continued on page 6.15→