Technogym Personal Selection TUV - Machines with Cross with Doubling Pulley

Personal Selection TÜV: Service & Maintenance Manual - rev. 1.0
Page 6.14
6.8.2. MACHINES WITH CROSS WITH DOUBLING PULLEY
This operation applies to Rotary Torso, Upper Back and Vertical Traction.
Photo 6.8-2
For machines with doubling pulley:
1. Loosen the cable tension and lock the levers.
2. Unscrew the screw a using an 8-gauge
hexagonal T-wrench, holding the nut b in
place with a 17-gauge wrench.
3. Remove the pulley and pulley cover to free
the cable.
Photo 6.8-3
4. Unscrew the 2 screws c, using an 8-gauge
hexagonal T-wrench.
5. Remove the support d.
Continued on page 6.15→