Technogym Personal Selection TUV - Page 40

Personal Selection TÜV: Service & Maintenance Manual - rev. 1.0
Page 6.8
Photo 6.5-4
6. Unscrew the 2 screws e, using a 4-gauge
hexagonal T-wrench, locking down the nuts
on the opposite side, using an 8-mm wrench.
7. Remove the sheet metal f by pulling it
forward.
Photo 6.5-5
For each side of the machine:
8. Unscrew the screw g using an 8-gauge
hexagonal T-wrench, holding the nut in place
with a 17-gauge wrench.
9. Remove the pulley h.
Remove the seat by pulling it upward.