Technogym Skillmill - Page 72

, the
pin may be faulty. Use the following troubleshooting procedure:
First, always upgrade the SW to the latest released version.
Rememberthat,fromtheSWversionSKILLMILLCONNECT:HighKit:BA01.49-wi-:CA01.16;
SKILLMILLCONSOLE: HighKit: BA01.49,afunction hasbeen addedat SW leveltoensure a
check of the correct calibration. For the details, refer to “6.7 Calibrating the brake table”.
OK. Problem solved.
Yes
Replace the angle sensor board [1].
Problem solved?
Yes
No
Replace the Low Kit (*)
No
Replace the pin [2].
Problem solved?
Yes
No
OK. Problem solved.
OK. Problem solved.
Calibrate the brake table
Problem solved?
The effort level does not change on the
display, but the real resistance level
perceived by the user does.
If the equipment SN is prior to DJK03D18001189,
DJK04D18000708, DJK13D18000313, DJK14D18000136,
loosen the sensor pin and then re�ghten it with the
torque specified in paragraph 7.8.2
Figure 40
Skillmill
Technical Service Guide - Rev. 3.5
Page 72
email: support@technogym.com