Technogym Skillmill - Page 80

6.6.10 BATTERY-POWERED SKILLMILL THAT TURNS ON AND OFF REPEATEDLY
Ifthebaery-poweredSkillmillturnsonandorepeatedly,thiscouldmeanthatthebaeryis
at:thedisplayisnotabletomanagetheresidualenergyandentersanon-oloopevenifthebelt
is not moving.
Carry out the following procedure:
1. Remove the front guard.
2. Removethebaery.
3. Disconnectthecablesconnectedtothebaeryandreconnectthemcorrectly.
4. Connecttheexternalbaerycharger.
5. Check the equipment is working.
6. Update the Low Kit to the latest version.
7. ReinstallthebaeryintheSkillmillandclosethefrontguard.
8. Chargethebaeryfor16hoursonboardtheequipment.
9. Iftheproblempersists,replacethebaery.
Fordetailsregardingbaeryoperation,see “3.1.6Baery(Consoleversion)”.
6.6.11 SKILLMILL DISPLAYS AN INCORRECT SPEED ON THE LCD/TURNS OFF AT A LOW
SPEEDS/ NOISY BELT
If the following problems occur on the Skillmill (Console or Connect):
• Noisy equipment (the RPM sensor rubs against the screws)
(Noisy operation may also be caused by the loosening of the ange bearing grub screws (for the details, see
“6.6.12 tread belt not straight/ belt noisy / belt derailment”)
• Incorrect speed shown on the LCD display
• Displayshutsoatlowspeeds*
carry out the following procedure:
Before intervening directly, make sure you have the correct screws/magnets. The codes can
be found in the spare parts catalogue, on Technogym Direct.
1. First, always upgrade the SW to the latest released version.
Skillmill
Technical Service Guide - Rev. 3.5
Page80
email: support@technogym.com