TECHVIEW QV-3034 - Alarm Settings and Device Management

6.3.3.4 Alarm Set
Click <Alarm> option to unfold its sub
1、 Motion Detection:
allow you
Capture> etc. Details setting should be consistent with DVR local setting (Shown as Picture 6
2、 I/O Alarm:
allow you configure <I/O Status>, <Alarm
etc. Details setting should be consistent with DVR local setting (Shown as Picture 6
6.3.3.5 Device
Click <Device> to unfold its sub
1.HDD: allow you
check out HDD status and overwritten time shown as Picture 6
consistent with DVR local setting.
35
Click <Alarm> option to unfold its sub
-
options: Motion, I/O Alarm shown as Picture 6
allow you
configure its <Sensitivity>, <Alarm out>, <Alarm record> and <Alarm
Capture> etc. Details setting should be consistent with DVR local setting (Shown as Picture 6
allow you configure <I/O Status>, <Alarm
output>, <I/O Alarm record> and <Alarm email>
etc. Details setting should be consistent with DVR local setting (Shown as Picture 6
Click <Device> to unfold its sub
-options: HDD and PTZ.
check out HDD status and overwritten time shown as Picture 6
Picture 6
-
25
Picture 6
-
26
Picture 6
-
27
Picture 6
-
28
User Manual
options: Motion, I/O Alarm shown as Picture 6
-25.
configure its <Sensitivity>, <Alarm out>, <Alarm record> and <Alarm
Capture> etc. Details setting should be consistent with DVR local setting (Shown as Picture 6
-26).
output>, <I/O Alarm record> and <Alarm email>
etc. Details setting should be consistent with DVR local setting (Shown as Picture 6
-27)。
check out HDD status and overwritten time shown as Picture 6
-28. Detail setting should be