TECHVIEW QV-3039 - 4.2 Live Interface; Chapter 5 DVR Menu

4.2 Live Interface
Note:
When internal HDD is not connected or an error occurs, the character “H”
channel of the live screen and accompany buzzer alarm. If you want to close the buzzer alarm, please enter
into [Main menu
Alarm] to set HDD loss, HDD space not enough and alarm output to “off”
Pop-up Menu
Picture
4
-
2
Picture 5
-
1
7
When internal HDD is not connected or an error occurs, the character “H”
channel of the live screen and accompany buzzer alarm. If you want to close the buzzer alarm, please enter
Alarm] to set HDD loss, HDD space not enough and alarm output to “off”
Chapter 5: DVR Menu
After finishing system initialization, click right
key of mouse on main interface mode to enter into
Pop-up Menu. Now you could
perform
setting and operate on
Main Menu, Multi
Auto Cruise, Zoom in/out, Rec.
record, Sequence, PIP,
and Vo Switch
Clicking [0] key on the remote controller or
holding press [Esc] key on the front panel could
switch system to other output device.
After finishing initialization the system will enter into
<Live> screen. Picture 4-2 is the
system, which is showing no video input status. Once there
are video inputs, the screen
will display live images from the
cameras. In Live
mode, if you use the mouse to double
the live image of any channel, the image will be maximized to
full screen, by double-
clicking again,
to 16-split display mode
; clicking the right button of the mouse
will enter into Pop-up Menu;
clicking the left button of the
mouse allows
you select menu items;
outside the menu allows you
exit the Pop
User Manual
When internal HDD is not connected or an error occurs, the character “H”
will appear on the first
channel of the live screen and accompany buzzer alarm. If you want to close the buzzer alarm, please enter
Alarm] to set HDD loss, HDD space not enough and alarm output to “off”
After finishing system initialization, click right
key of mouse on main interface mode to enter into
perform
parameter
Main Menu, Multi
-Pics, PTZ,
Auto Cruise, Zoom in/out, Rec.
Search, Manual
and Vo Switch
etc.
Clicking [0] key on the remote controller or
holding press [Esc] key on the front panel could
switch system to other output device.
After finishing initialization the system will enter into
16-split display defaulted by
system, which is showing no video input status. Once there
will display live images from the
mode, if you use the mouse to double
-click
the live image of any channel, the image will be maximized to
clicking again,
image will be come back
; clicking the right button of the mouse
clicking the left button of the
you select menu items;
and clicking any area
exit the Pop
-up menu.