TECHVIEW QV-3039 - Network Parameters; Record

6.3.3.2 Record
Click <Record> option to unfold its sub
6.3.3.3 Network Parameters
Unfold <Network> option to enter into its sub
configuration.
1、Network
Picture 6-15
Picture 6
-
17
Picture 6-18
Picture 6-19
34
Click <Record> option to unfold its sub
-
options: Record parameter, Schedule and Main stream.
Unfold <Network> option to enter into its sub
-
options: Network, sub stream, Email, mobile and DDNS
1、
Record Parameters:
option, allow
you set channel, record enable, pack time
and Pre-
record status shown as Picture 6
2、 Schedule:
Detailed parameters please refer to DVR
local setting (shown as Picture 6
Green stand for Normal record; Yellow stands for
Motion detection; Red stands fo
3、 Main Stream:
detailed settings please refer to DVR
local setting (shown as Picture 6
modifies the resolution, frame rate, Bit rate and audio
of the record channel.
1、
The model support three network type, including Static,
DHCP and PPPoE. System default <Static> as its
network type. Us
er could allocate IP and perform Port
forwarding for DVR according to different router. When
set <UPNP> to “On”, user no needs to perform port
forwarding. Once you modify the network parameters
successfully, DVR will automatically restart.DVR
For details p
arameters please refer to below Picture 6
Picture 6-19 and Picture 6-
20.
Picture 6
Picture 6
User Manual
options: Record parameter, Schedule and Main stream.
options: Network, sub stream, Email, mobile and DDNS
Record Parameters:
Under [Record parameters]
you set channel, record enable, pack time
record status shown as Picture 6
-15;
Detailed parameters please refer to DVR
local setting (shown as Picture 6
-16).
Green stand for Normal record; Yellow stands for
Motion detection; Red stands fo
r I/O triggered record.
detailed settings please refer to DVR
local setting (shown as Picture 6
-16). Herein allow user
modifies the resolution, frame rate, Bit rate and audio
The model support three network type, including Static,
DHCP and PPPoE. System default <Static> as its
er could allocate IP and perform Port
forwarding for DVR according to different router. When
set <UPNP> to “On”, user no needs to perform port
forwarding. Once you modify the network parameters
successfully, DVR will automatically restart.DVR
arameters please refer to below Picture 6
-18,
20.
Picture 6
-16
Picture 6
-20