Section 8 – GROUND HANDLING & SERVICE
MAINTENANCE
4.3 LANDING GEAR TIRES PRESSURE CONTROL
For each wheel proceed as follows:
1. Remove wheel fairing
2. Unscrew the tire cap
3. Connect a gauge
4. Read the pressure value
5. If required, rectify the pressure (nose tire 2.2 Bar / 32 psi, main landing
gear tires 2.5 Bar / 36 psi)
6. Fit the tire cap
7. Install wheel fairing
FIG. 8-2. TIRE PRESSURE PLACARDS
To Next Page
Loading...
