EasyManua.ls Logo

Tecnam P2010 - Page 456

Tecnam P2010
587 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
st
Edition, Rev. 0
Section 4 Normal procedures
AUTOPILOT MODES
AFMS N°D07 FOR GARMIN GFC700 AUTOPILOT AND VARIABLE PITCH PROPELLER EQUIPPED
AEROPLANES
Page APV4-29
ALTITUDE HOLD MODE (ALT)
Turning the ALT knob while in Altitude Hold Mode changes the Selected Al-
titude, but not the FD Altitude Refrence, and does not cancel the
mode
FLC MODE
The Selected Altitude MUST be set before selecting Flight Level Change
Mode.FLC IAS selection is directly linked to actual IAS, pilot will need to
monitor airspeed after selection of FLC mode.
VERTICAL NAVIGATION MODES (VPTH, ALTV)
VNV is disabled when parallel or dead reckoning mode is active
The selected altitude takes precedence over any other vertical constraints.
If another pitch mode key is pressed while Vertical Path Tracking Mode is
selected, VPTH mode reverts to armed.
If the selected altitude is not at least 75 ft below the VNV Target Altitude,
the FD captures the Selected Altitude once Vertical Path Tracking Mode
become active (ALTS is armed rather than ALTV).
Altitude preselect must show an altitude below the flight plan’s Target Alti-
tude.
If the selected altitude is not at least 75 ft below the VNV Target Altitude,
the FD captures the Selected Altitude once Vertical Path Tracking Mode
become active (ALTS is armed rather than ALTV).
If VPTH is armed more than 5 minutes prior to descent path capture,
acknowledgement is required for the FD to transition from Altitude
Hold to VPTH
To proceed with descent path capture if the white “VPTH” flashes,do the
following:
- Press VNV Kay
- Turn ALT knob to adjust the Selected Altitude.
If the selected altitude is not at least 75 ft below the VNV Target Altitude,
the FD captures the Selected Altitude once Vertical Path Tracking Mode
become active (ALTS is armed rather than ALTV).
Armed VNV Target Altitude and Selected Altitude capture modes are
mutually exclusive. Selected Altitude Capture Mode is armed also (not
annunciated) whenever VNV Target Altitude Capture Mode is armed
APPROACH MODES
The selected navigation receiver must have a valid VOR or LOC signal or
active GPS course for the flight director to enter Approach Mode

Table of Contents

Other manuals for Tecnam P2010

Related product manuals