03- External Terminals Digital Input/Output Function Group
03- 00 Multi-function terminal function setting – S1
03- 01 Multi-function terminal function setting – S2
03- 02 Multi-function terminal function setting – S3
03- 03 Multi-function terminal function setting – S4
03- 04 Multi-function terminal function setting – S5
03-05 Multi-function terminal function setting – S6
03-06 Multi-function terminal function setting – S7
03-07 Multi-function terminal function setting – S8
Range
【0】:
2-Wire sequence (ON : Forward run command)
【1】:
2-Wire sequence (ON : Reverse run command)
【2】: Multi-speed/position setting command 1
【3】: Multi-speed/position setting command 2
【4】: Multi-speed/position setting command 3
【5】: Multi-speed/position setting command 4
【6】:
Forward jog run command
【7】:
Reverse jog run command
【8】: UP frequency increasing command
【9】: DOWN frequency decreasing command
【10】: Acceleration/deceleration setting command 1
【11】: Inhibit Acceleration/deceleration Command
【12】:
Retain
【13】:
Retain
【14】:
Emergency stop (decelerate to zero and stop)
【15】: External Baseblock Command(rotation freely to stop)
【16】:
PID control disable
【17】:
Fault reset (RESET)
【18】:
Retain
【19】:
Speed Search 1 (from the maximum frequency)
【20】:
Manual energy saving function
【21】:
PID integral reset
【22】:
Retain
【23】:
Retain
【24】:
PLC input
【25】:
External fault
【26】:
3-Wire sequence (Forward/Reverse command)
【27】:
Local/Remote selection
【28】:
Remote mode selection
【29】:
Jog frequency selection
【30】: Acceleration/deceleration setting command 2
【31】:
Inverter overheating warning
【32】:
Sync command
【33】:
DC braking
【34】:
Speed Search 2 (from the frequency command)
【35】:
Time function input
【36】:
PID Soft start invalid
【37】: Traversing operation
【38】: Upper Deviation of traverse operation
【39】: Lower Deviation of traverse operation
【40】: Switching between motor 1/motor 2
To Next Page
Loading...
