TECO A510-2001-H - Chapter 4 Software Index; 4.1 Keypad Description; 4.1.1 Panel Functions

4-1
Chapter 4 Software Index
4.1 Keypad Description
4.1.1 Panel Functions
Type Name Functions
Main display area
Display frequency, parameter voltage, current, temperature and
abnormity and ect.
Display
LED status display
FAULT: When the inverter has a warning or fault message, the
indicator lights up.
FWD: When the inverter is in forward rotation status, the
indicator lights up.
(long bright light while inverter running, flicker while
inverter stopping)
REV: When the inverter is in reversal rotation status, the
indicator lights up.
(long bright light while inverter running, flicker while
inverter stopping)
SEQ: When inverter’s run command source is set to external
control, the indicator lights up.
REF: When inverter’s frequency command source is set to
external control, the indicator lights up.
RUN RUN: Enable the inverter run operation.
STOP STOP: Enable the inverter stop operation.
▲
It is used for frequency and parameter setting.
▼ It is used for frequency and parameter setting.
FWD/REV
This key is used for switching motor’s rotation direction. FWD
indicator on means the motor is rotating in forward direction;
REV indicator on means the motor is rotating in reversal
direction.
DSP/FUN
It is use for switching dispay interface, based on the loop of
frequency screen Æfunction selectionÆmonitor parameterÆ
frequency screen.
</RESET
“<” is left shift key. It is used for changing parameter or value.
RESET key：when a fault is detected, it plays reset function .
Keys
（8 keys）
READ/ENTER
Switch to enter the functions and set internal value, as well as
modify parameter setting and confirm the writing.