TECO A510-2001-H - 4.1.2 Display Description

4-2
4.1.2 Display Description
Digital and letter display
Actual LED Display Actual LED Display Actual LED Display Actual LED Display
0
A
L
Y
1
B
n
-
2
C o
°
3
D
P
_
4
E
q
.
5
F
r
6
G S
7
H
t
8
I
u
9
J
V
Description of seven-segment display
Actual output frequency
Display mode of frequency
command
Modification mode of
frequency command
LED lights on LED flashes
Position the flashing location
（change the position ）
In Idle status: Seven-segment LED display is for frequency setting, all LEDs are flashing. If UP / DOWN
key is pressed, it will enter the modification mode and the user can change the frequency command. The
flashing position will change according to the </ RESET key. Press READ / ENTER key to write
frequency command and switch to the status of frequency display mode. If the READ / ENTER key is not
pressed within 5 seconds under frequency modification mode, it will switch back to frequency display
mode.
In operating status: Seven-segment LED shows the actual output frequency, its LED is constant
lighting. If UP / DOWN key is pressed, it will enter the frequency command modification mode. The
flashing position will change according to the </ RESET key. If the inverter is in operation, after press
READ / ENTER key to write frequency command, it switches immediately to the status of actual output
frequency display mode.