TECO A510-2001-H - Page 299

6-13
B. JN5-PG-L speed feedback card: Line driver speed feedback card:
. JN5-PG-L terminal specification
Terminal Name Description
Vcc
JN5-PG-L Card output power;
12V/5V±5% ,200mA(voltage is selected by the SW1 )
GND Power and signal reference point
A, A\, B, B\, Z, Z\
Encoder input signal, A correct divider ratio output
requires a two-phase input.
line driver input type, RS-422 level input
AO, AO\, BO, BO\, ZO, ZO\
A, B phase divider ratio ouput, z phase output monitor,
line driver output type, RS-422 level output
E Ground terminal
. JN5-PG-L wiring example
C. JN5-PG-PM speed feedback card : synchronous motor line driver speed feedback
card :
. JN5-PG-PM terminal specification
Terminal Name Description
Vcc
JN5-PG-PM Card output power； 5V±5% ,200mA
GND Power and signal reference point
A, A\, B, B\, Z, Z\
U, U\, V, V\, Z, Z\
Encoder input signal, A correct divider ratio output
requires a two-phase input.
line driver input type，RS-422 level input
AO, AO\, BO, BO\, ZO, ZO\
A ,B phase divider ratio ouput, z phase output monitor,
line driver output type，RS-422 level output
E Ground terminal