6-15
B. Analog Operator
‧For A510, in addition to the standard LED digital operator and optional LCD digital
operator, an analog pointer operation panel JNEP-16 can be installed (as below figure),
pull-out type removable operation panel. Its wiring with the inverter is shown as
following:
R
S
T
R
S
T
配路用斷路器
正向運轉
停止
SC
1
2
3
4
15V 速度設定用電源
(+15V, 20 mA)
GND 0V
VIN 主速指令
0 ~ 10V
2k
Ω
主速頻率設定
976
Ω
, 1/4 W
A01
GND
FM
類比輸出
B1/P B2
V
W
IM
U
RA
RB
RC
多機能接點輸出
250V AC, 1A 以下
30V DC, 1A 以下
DO1
DOG
DO2
多機能輸出 1, 2
(OPEN COLLECTOR
48V, 50mA)
運轉中
頻率一致
7200MA
類比式操作器
(JNEP-16)
(a) Apperance (b) Wiring diagram
Figure 9 Analog operation panel
C. LED digital operator can be pulled out for operation. The extension wire with different
specification can be chosen according to the requirement.
L Extension wire *1
1m JN5-CB-01M
2m JN5-CB-02M
3m JN5-CB-03M
5m JN5-CB-05M
* 1: with special isolated wired extension wire, blank operation box, mounting screws and
instructions.
* 2: with a piece of special isolated wired extension wire.
* 3: blank operation box is used to mount on the original position of the digital operator, to
prevent falling foreign objects and increase the aesthetic.
Inverter
Breaker for wiring
Forward operation
Stop
Main speed frequency
setting
Analog operator
Power for speed
setting
Main speed
command
Analog output
Multifunction contacts out
To Next Page
Loading...
