TECO A510-2001-H - PID control Setting

4-36
Group 12 Monitoring Function Group
Control mode
Code Parameter Name Range Default Unit
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
A
ttrib
ute
0000 0000
Input Terminal(S8)
Input Terminal(S7)
Input Terminal(S6)
Input Terminal(S5)
Input Terminal(S4)
Input Terminal(S3)
Input Terminal(S2)
Input Terminal(S1)
0：OPEN
1：CLOSE
000
Output Terminal(DO1)
Output Terminal(R2)
Output Terminal(R1)
12-06 Retain
12-07 Retain
12-08 Retain
12-09 Retain
12-10 Retain
12-11
Output current of
current fault
Display the output current of
current fault
- A O O O O O O
12-12
Output voltage of
current fault
Display the output voltage of
current fault
- V O O O O O O
12-13
Output frequency of
current fault
Display the output frequency of
current fault
- Hz O O O O O O
12-14
DC voltage of current
fault
Display the DC voltage of
current fault
- V O O O O O O
12-15
Frequency command
of current fault
Display the frequency
command of current fault
- Hz O O O O O O
12-16 Frequency command
If LED enters this parameter, it
only allows monitoring
frequency command.
- Hz O O O O O O
12-17 Output frequency
Display the current output
frequency
- Hz O O O O O O
12-18 Output current
Display the current output
current
- A O O O O O O
12-19 Output voltage
Display the current output
voltage
- V O O O O O O
12-20 DC voltage (Vdc) Display the current DC voltage - V O O O O O O
12-21 Output power(kw)
Display the current output
power
- kW O O O O O O
12-22
Motor’s rotation speed
(rpm)
Display motor’s current rotation
speed
in VF/SLV mode
Motor’s rotation speed =
output power x(120/motor’s
pole number)
In PG/SV mode, motor’s
rotation speed is calculated by
feedback frequency.
- rpm O O O O O O
12-23
Output power factor
(Pfo)
Display the current output
power factor
- - O O O O O O
12-24 Control mode
Display control mode
0 : VF 1 : PG
2 : SLV 3 : SV
- - O O O O O O