TECO A510-2001-H - PID fine tuning

4-38
Group 12 Monitoring Function Group
Control mode
Code Parameter Name Range Default Unit
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
A
ttrib
ute
maximum frequency set by
01-02 or 01-16)
12-37 PID output
Display output of the PID
controller
(100% corresponds to the
maximum frequency set by
01-02 or 01-16)
- % O O O O O O
12-38 PID setting
Display the target value of the
PID controller
(100% corresponds to the
maximum frequency set by
01-02 or 01-16)
- % O O O O O O
12-39 PID feedback
Display the feedback value o
f
the PID controller
(100% corresponds to the
maximum frequency set by
01-02 or 01-16)
- % O O O O O O
12-40
Motor’s cumulative
output energy
Display motor’s cumulative
output energy
-
KW
Hr
O O O O O O
12-41 Heatsink temperature
Display the heatsink
temperatureof IGBT
temperature.
-
Deg
ree
C
O O O O O O
12-42 RS-485 error code
Display the status of RS-485
0000 0000
CRC error
0：normal
1：abnormal
Data length error
Parity error
Overrun error
Framing error
Time out
Reserved
- - O O O O O O
12-43 Inverter status
0000 0000
1: Inverter ready
1: During running
1: During zero speed
1: During speed agree
1: During fault detection (minor fault)
1: During fault detection (major fault)
Reserved
- - O O O O O O
12-44 Pulse input frequency
Display the frequency value o
f
pulse input
- Hz O O O O O O
12-45 Recent fault message Display current fault message - - O O O O O O
12-46 Previous fault message Display previous fault message - - O O O O O O
12-47
Previous two fault
messages
Display previous two fault
messages
- - O O O O O O
12-48
Previous three fault
messages
Display previous three fault
messages
- - O O O O O O
12-49
Previous four fault
messages
Display previous four fault
messages
- - O O O O O O
12-50
DIO status of current
fault
Display the DI/DO status o
f
current fault
- - O O O O O O