TECO L510S Series - Page 127

4-82
11-18 Speed loop proportion gain
Range
【
0~65535】
11-19 Speed loop integration gain
Range
【
0~65535】
11-20 Speed loop differential gain
Range
【
0~65535】
 SLV control mode use a output speed estimator as speed feedback value. Speed control system
to adjust the output frequency to follow the value of speed feedback command. The output torque
command is by the controller output with a limiter.
11-21 Stop Key Selection
Range
【
0】：Enable Stop Key when Run Command not from Keypad
【1】：Disable Stop Key when Run Command not from Keypad
 When run command comes from control terminal (00-02=1) or communication (00-02=2), this
parameter can be enabled or disabled the stop key function of operator.