TECO L510S Series - Chapter 0 Preface; 0.1 Preface

0-1
Chapter 0 Preface
0.1 Preface
To extend the performance of the product and ensure personnel safety, please read
this manual thoroughly before using the inverter. Should there be any problem in
using the product that cannot be solved with the information provided in the manual,
contact our technical or sales representative who will be willing to help you.
※Precautions
The inverter is an electrical product. For your safety, there are symbols such as
“Danger”, “Caution” in this manual as a reminder to pay attention to safety
instructions on handling, installing, operating, and checking the inverter. Be sure to
follow the instructions for highest safety.
Danger
Indicates a potential hazard that could cause death or serious
personal injury if misused.
Caution
Indicates that the inverter or the mechanical system might be damaged
if misused.
Danger
 Risk of electric shock. The DC link capacitors remain charged for five
minutes after power has been removed. It is not permissible to open the
equipment until 5 minutes after the power has been removed.
 Do not make any connections when the inverter is powered on. Do not check
parts and signals on circuit boards during the inverter operation.
 Do not disassemble the inverter or modify any internal wires, circuits, or
parts.
 Ensure that the Inveter Ground terminal is connected correctly.
Caution
 Do not perform a voltage test on parts inside the inverter. High voltage can
destroy the semiconductor components.
 Do not connect T1, T2, and T3 terminals of the inverter to any AC input
power supply.

CMOS ICs on the inverter’s main board are susceptible to static electricity. Do
not touch the main circuit board.