TECO L510S Series - Page 130

4-85
13 Inspection & Maintenance functions
13- 00 Drive Horsepower Code
Range
----
Inverter
Model:
13- 00
show
Inverter Model: 13- 00
show
Inverter
Model:
13- 00
show
L510-1P2-SXX 1P2 L510-2P2-SXX 2P2 L510-401-SXX 401
L510-1P5-SXX 1P5 L510-2P5-SXX 2P5 L510-402-SXX 402
L510-101-SXX 101 L510-2P7-SXX 2P7 L510-403-SXX 403
L510-201-SXX 201 L510-405-SXX 405
L510-202-SXX 202 L510-408-SXX 408
L510-203-SXX 203 L510-410-SXX 410
L510-205-SXX 205 L510-415-SXX 415
L510-208-SXX 208
L510-210-SXX 210
13- 01 Software Version
Range
----
13- 02 Fault Log Display (Latest 3 faults)
Range
----
 Last three faults are stored in a stack and whenever there is a new fault the previous faults
are pushed down the stack. So the fault stored in 2.xxx will be transferred to 3.xxx, and the
one in 1.xxx to 2.xxx. The recent fault will be stored in the empty register 1.xxx.
 Use Up▲and Down▼ keys to scroll between the fault registers.
 Pressing reset key when parameter 13-02 is displayed then all three fault registers will be
cleared and the display for each register will change to 1. ---, 2. ---, 3. ---.
 E.g. fault log content is ‘1.OC-C’; this indicates the latest fault is OC-C, etc.
13- 03 Accumulated Inverter Operation Time 1
Range
【0~23】Hours
13- 04 Accumulated Inverter Operation Time 2
Range
【0~65535】Days
13- 05 Accumulated Inverter Operation Time Mode
Range
【0】:Power on time
【1】:Operation time
 When the operation time recorded in accumulator 1(Parameter 13-03) reaches 24 hours

The recorded value in accumulator 2 parameter 13-04 changes to 1 day and the value in
accumulator 1 is reset to 0000.
13- 06 Parameter lock
Range
【0】: Enable all Functions
【1】: Preset speeds 05- 01~05- 08 cannot be changed
【2】: All Functions cannot be changed Except for preset speeds set in
05-01~05- 08
【3】: Disable All Function Except 13-06
 When the 13-07=00000, you can adjust the parameters 05-01~05-08 from 13-06.