Chapter 3: Menu reference > Option 14 Program Users
Challenger10 Administrators Manual 33
*-View, Alm Grp:1-No Access
Alarm Group:
Enter the number of the alarm group, and then press [ENTER] to assign the
alarm group to the user. Alternatively, press [NEXT] to display a list of alarm
groups that you can issue to a user.
Notes:
• You cannot assign an alarm group to a user unless the alarm group has the
option “Can this Alarm Group be Assigned to Users” set to YES
• Your alarm group must have all the areas and menu options of the alarm
group you wish to assign.
• Your alarm group may contain Area Group 1, which, by default, does not
contain all 99 areas. Area Group 1 may need to be modified so that it
contains all the required areas for your users. Refer to “Working with multi-
area systems” in the Challenger10 Installation and Quick Programming
Manual for details.
Press [ENTER] to display or change the user’s door group.
Door Group: 0
Door Group
Press [ENTER] to display or change the user’s floor group.
Floor Group: 0
Floor Group
Press [ENTER] to display or change the first of the user flags (if the system is
programmed to display user flags).
NO - Dual Custody
*-Change 0-Skip
If required, press [MENU*] to toggle the programmed value from NO to YES, and
then press [ENTER] to display subsequent user flags. Alternatively, press [0] to
skip the subsequent user flags.
The user flags displayed in sequence are:
• dual custody
• guard
• visitor
• trace user
• card only
• privileged
To Next Page
Loading...
