Chapter 3: Menu reference > Option 14 Program Users
34 Challenger10 Administrators Manual
• long access
Press [ENTER] to program or display the user’s name (if the system is
programmed to allow user name files), for user numbers in the range 1 to 2000.
Your Name is David Chisma
(1)-Edit
Enter up to 16 characters of text for the user’s name (see “Entering text via RAS”
on page 9).
When you’ve finished entering the name, press [MENU*] [MENU*] to save the
name, exit the option, and then to display the user’s PIN code (if the system is
programmed to allow users other than the master installer to see PIN codes).
Pin Code: 4346
Code:
The minimum PIN code length is 4 digits (5 for financial institutions), plus any
value programmed for the alarm code prefix. For example, if your system uses
an alarm code prefix value of 2 (digits) then you must program PIN codes of at
least 6 digits (4 + 2).
Press [ENTER] to save the PIN code, and then to learn the card data from a
reader.
Waiting For Card
*- Hist
Do one of the following:
• Present a card at the designated card learn reader, and then press [ENTER]
to save the card bit data in the user record. See “Learning card data” below.
• Press [MENU*] to use unknown card data from the Challenger panel’s history.
See “Using data from card history” on page 35.
• Press [ENTER] to manually enter the card data bits. See “Manually entering
card data” on page 35.
Learning card data
At the Waiting For Card prompt, present a card at the designated card learn
reader. The LCD screen displays the card bit data.
Card Bits: 27.0.0.0.25.0.6
Bits:
Press [ENTER] to save the card bit data in the user record, and then return to the
Create User screen.
To Next Page
Loading...
