Teknatool NOVA DVR XP - Control Functions and Settings; Drive Parameter Settings

115-0214-004
27
4.0 CONTROL FUNCTIONS
Drive Parameter Settings (Set Function)
HMI display lines contain the parameters, which can be edited.
Press key
UP
RPM
to incrementally increase the parameter or
DOWN
RPM
to decrease it.
Hard Reset Function
Press key
0
OFF
, hold it and then press key
DOWN
RPM
in order to provide the Hard Reset of the drive.
Another way is to switch off the power, wait 10 seconds and switch it on again. Use this function if you
want to return the factory-preloaded values of the drive parameters. Also, try to use this function if you
have a problem with the drive, for example, if the system is not responding to the keys.