DC-395 Series User’s Manual
4040
6. OS/2 DRIVERS
This chapter provides driver installation and un-installation instructions for IBM OS/2 v2.x
and Warp 3.0/4.0. There are three driver files under the \OS2DRV directory on the software
diskette:
• TRM3X5.ADD is the DC-395's OS/2 Adapter Device Driver that is fully compatible with
OS/2 v2.x and Warp 3.0
• TRM3X5.DDP contains installation instruction.
6.1 New OS/2 Installation
The following procedures are for a new OS/2 installation or upgrading to a newer version
of OS/2. To add a DC-395 to an existing OS/2 system, see next section.
1. Make a copy of the OS/2 Setup Disk 1. Label this disk "DISK 1A" - The original DISK
1 will not be used again in these procedures.
2. Copy the file TRM3X5.ADD from the directory \OS2DRV on the Tekram driver disk to
the root directory of "DISK 1A" made in step 1.
3. Edit the CONFIG.SYS of DISK 1A. At the end of the file, add the following line:
BASEDEV=TRM3X5.ADD
Then, add one more line at the end of the CONFIG.SYS:
SET COPYFROMFLOPPY=1
4. Remove DISK 1A and insert the OS/2 Installation diskette. Boot from this disk to begin
the OS/2 installation.
5. A blue screen will prompt for the OS/2 DISK 1. Insert DISK 1A instead and proceed
with the installation. The driver for the DC-395 will be loaded automatically.
6.2 Adding the Driver to an Existing OS/2 System
1. Double click the "Device Driver Install" Icon.
* This icon is located in the System Setup folder under OS/2 2.X/3.X/4.X
* Under OS/2 4.X, this icon resides in the System Setup -> Install/Remove folder.
2. Insert the DC-395 Driver diskette in the floppy drive.
3. Change the SOURCE directory to A:\OS2 and click SET.
To Next Page
Loading...
