4. DOS ASPI DRIVERS & UTILITIES
DC-395 Series User’s Manual
2424
4.1 Easy DOS Driver Installation Software (INSTALL.EXE)
The DOS driver diskette provides an INSTALL.EXE file in the \DOS directory to provide
easy driver installation for your SCSI devices. Under DOS, the driver installation will be
necessary if either:
a) More than two Hard Drives are installed and "More Than 2 Drives Support" is
disabled (sec.3.2.2), or
b) A SCSI device other than a Hard Drive is installed (CD-ROM, etc.)
This software program provides you with information about the adapter and your SCSI
devices. After choosing the device(s) that you want to install drivers for, Install will update
the CONFIG.SYS and AUTOEXEC. BAT files automatically. Further information about
drivers and step-by-step installation procedures can be found in Chapter 3: DOS ASPI
DRIVERS & UTILITIES.
The following screens illustrate the DOS driver install procedure:
1. To begin, this screen displays information about the adapter number (HA#0), I/O port
address (Base E400H), interrupt level (IRQ 11), and SCSI ID (ID 7). In this case, there
is only one adapter installed. If there are two or more adapters coexisting in your system,
select which adapter you want to work with.
The system has the following Host Adapter(s)
1 DC-3x5 HA#0 Base E400H IRQ 11 ID7
2. This screen provides information regarding the SCSI devices controlled by the chosen
adapter (HA#0).
The system has the following SCSI devices:
Dev# HA# SCSI ID# Vendor ID Product ID Revision Level
0 0 0 FUJITSU M2614S 0607
1 0 1 MAXTOR LXT-200S 2.11
2 0 3 NEC CD-ROM DRIVE: 04 1.0
3. After selecting a device, more detailed information is displayed. For example, selecting
the Fujitsu drive brings up a window like so:
To Next Page
Loading...
