7. WINDOWS NT DRIVERS7. WINDOWS NT DRIVERS
DC-395 Series User’s Manual
4444
4. Press "S" to skip mass storage device detection. The next screen will show: “Setup has
recognized the following SCSI Adapters in your computer: (none).” Choose to configure
an additional SCSI adapter by pressing "S", and continue with the following steps:
5. On the next screen, NT will show various drivers. Choose: "Other (Required disk
provided by a hardware manufacturer)" and press “ENTER”.
6. NT will prompt for the "Manufacturer-supplied support disk". Insert the DC-395 driver
diskette in drive "A" and press “ENTER”.
7. NT will check the floppy and show:
"Tekram DC-395U/UW/F or DC-315/U NT 3.51 & 4.x PCI SCSI Driver Ver. XXX"
Select the NT version you want to install and press "ENTER".
8. After NT scans the hardware and finds the controller, it will display:
“Setup has recognized the following Mass Storage device in your computer:"
"Tekram DC-395U/UW or Dc-315?U PCI SCSI Adapter Ver. XXX"
Press “ENTER” to continue and copy the driver files. At this point, simply follow the
Microsoft Windows NT installation procedure.
7.1.2 Boot from CD-ROM :
You can boot from CD-ROM when you set the CD-ROM as a boot device from Main Board
BIOS for ATAPI CD-ROM or DC-395U/UW boot up screen for SCSI CD-ROM.
1. Press "F6" key when the screen shows" Setup is inspecting your Computer's hardware
Configuration".
2. The next screen will show: "Setup could not determine the type of one or more mass
storage device installed in your system ...". Choose to configure and specify additional
SCSI adapter by pressing "S".
3. On the next screen, NT will show various drivers. Choose: "Other (Required disk
provided by a hardware manufacturer)" and press "ENTER".
4. NT will prompt for the "Manufacturer-supplied hardware support disk" into drive A:
Insert the DC-395 driver diskette in drive "A" and press "ENTER".
5. NT will check the floppy and show:
"Tekram DC-395U/UW/F or DC-315/U NT 3.51 & 4.x PCI SCSI Driver Ver. XXX"
and press "ENTER".
To Next Page
Loading...
