DC-395 Series User’s Manual
5555
APPENDIX
A. Specifications
PCI Features
• PCI Specification Revision 2.1 compliant with full PnP support by host adapter's BIOS
• High speed 32-bit PCI bus master DMA transfers of up to 132 Mbyte/sec in burst mode
• Direct glueless interface to 33MHz, 32-bit PCI bus
• Support for Scatter-Gather DMA data transfers
• Multiple-byte DMA FIFO for low bus latency
SCSI Features
SCSI Protocol Max. sync.
data Xfer rate
Max.
Devices
Model No.
SCSI-I SCSI-II SCSI-3
DC-395U
4 4 4
20 7
DC-395UW/F
4 4 4
40 15
• Boot ROM support
• On-chip state machine to control the SCSI sequences in hardware
• Target Command Set Support
• Single-Ended 48mA outputs to drive the SCSI bus directly
Overall Features
• Supports Flash BIOS
• Level Triggering support allows multiple adapters to share a single interrupt
• Coexists with other SCSI, ESDI, or IDE adapters
• Supports up to eight drives in DOS 5.0/6.x without the need for device drivers
• Complete software driver support for all major PC operating systems
• User friendly utility for quick and easy adapter installation and system configuration.
To Next Page
