5. NETWARE DRIVERS
DC-395 Series User’s Manual
3535
5.1.3 NetWare 3.12/SFT-III
This subsection covers the installation of the driver module DC3X5.HAM and DC3X5.DDI
for NetWare Versions 3.12/SFT-III.
1. Download those two files:NWPA_UP.EXE and 312PTD.EXE from Novell website
address: at http://developer.novell.com/devres/sas/certinfo.htm at Download Upgrade
Package for NetWare v3.12.
2. Copy NWPA_UP.EXE and 312PTD.EXE to C:\SERVER_312 directory.
3. Copy DC3X5.HAM and DC3X5.DDI to C:\SERVER_312 directory.
4. Execute NWPA_312.EXE in the same directory.
5. Execute 312PTD.EXE in the same directory.
6. Change directory to the C:\SERVER.312\312PTD\NATIVE\LOADER
lswap loader.exe C:\SERVER.312\SERVER.EXE
CD\SERVER
7. Create the directory C:\SERVER.312\CDSAVE
8. Copy CDROM.NLM to C:\SERVER.312\CDSAVE
9. Change directory to the C:\SERVER.312\312PTD\NATIVE\LOADER
lswap loader.exe C:\SERVER.312\SERVER.EXE
CD\SERVER
10. Enter install at DOS command line. Proceed through the installation of NetWare v3.12
as usual, until the installation program ends with the cursor at the server console
command line.
11. At the server console enter the following commands.
Load C:\SERVER.312\312PTD\NATIVE\START\NPAPATCH
Load C:\SERCER.312\MMATTRFX
Load C:\SERVER.312\NBI31X
Load C:\SERVER.312\DC3X5.HAM
12. The install program will then require you to install additional server drivers. You may
see a message stating that the driver did not load in the time allowed. Following that,
you should see a message like that below:
To Next Page
Loading...
