Tekram Technology DC-395U - Managing OS;2 Driver Installation

6. OS/2 DRIVERS
DC-395 Series User’s Manual
4141
4. Change the DESTINATION directory to OS2\BOOT or OS2 (for OS/2 version 2.x only)
and click SET.
5. Select Install and then Exit to complete the driver installation.
You may also install the driver manually:
1. Copy the file TRM3X5.ADD from the directory \OS2 on the Tekram driver disk to the
directory C:\OS2.
2. Edit C:\ CONFIG.SYS. At the beginning of the file, add the following line:
BASEDEV=TRM3X5.ADD
Note1: If OS/2 is booting from an IDE drive, the line: BASEDEV=TRM3X5.ADD must
appear after the line that loads the IDE driver (e.g. IBM1S506.ADD) in the
CONFIG.SYS
Note2
: If your OS/2 is installed to IDE drive from SCSI CD-ROM drive, TRM3X5.ADD
will be located at the first line in C:\CONFIG.SYS after installation. Before booting
OS/2 from IDE drive, modify the file C:\CONFIG.SYS as described in Note1.
6.3 Un-installing the Driver
1. Edit the C:\CONFIG.SYS file.
Modify the line:
BASEDEV=TRM3X5.ADD
to:
REM BASEDEV=TRM3X5.ADD
2. Re-boot the system.