Tekram Technology DC-395U - Adding Driver to Existing NT System

7. WINDOWS NT DRIVERS7. WINDOWS NT DRIVERS
DC-395 Series User’s Manual
4545
6. After NT scans the hardware and finds the controller, it will display:
"Setup has recognized the following Mass Storage devices in your computer:"
"Tekram DC-395U/UW/F or DC-315/U PCI SCSI Adapter Ver. XXX"
7. Press "ENTER" to continue and copy the driver files. At this point, simply follow the
Microsoft Windows NT installation procedure.
7.2 Adding the Driver to an Existing NT System
7.2.1 For NT Versions 3.5x
1. Boot NT.
1. From the Main Program group, double click the Windows NT Setup icon.
2. From the "Option" pull-down menu, select "Add/Remove SCSI Adapters".
3. Click the "Add" button and select "Other (Requires a disk form a hardware
manufacturer)".
4. NT will prompt you to insert the "Manufacturer-supplied support disk". Insert the DC-
395 driver diskette into drive A: and type in the path:
A:\WINNT\3_51-4_x (For NT versions 3.51 and 4.0)
5. Windows NT will show: "Tekram DC-395U/UW/F or DC_315/U PCI SCSI Adapter
Ver. XXX". Select "OK"
6. Windows NT will display "Adapter: Tekram DC-395 PCI SCSI Adapter Ver. XXX"
Select "Install".
At this point, if the specified driver has already been installed, NT will display "The
drivers for this adapter are already on the system" Select "Current" if you want to use
existing driver, or select "New" if you want to replace or upgrade the current driver.
7. Select "OK" to return to the Windows NT Setup program.
8. Shut Down and restart the system.