DC-395 Series User’s Manual
4343
7. WINDOWS NT DRIVERS
This chapter provides driver installation and un-installation procedures for Windows NT
3.51/4.x:. There is one driver directories under the \WINNT directory of the driver diskette,
for NT 3.51/4.x:
\WINNT\3_51-4_x
Trm3X5.sys:
(*)
Device driver for NT 3.51
& 4.x
Oemsetup.inf: Device information file
Trm3X5.inf Device information file
And two others are under the root directory:
• TXTSETUP.OEM (Text Setup File)
• DCSCI (Text Setup Tag File)
7.1 New Windows NT Installation
You can boot Microsoft Windows NT from Setup Diskette or CD-ROM. The following is the
procedure for installing the Tekram adapter driver while installing Windows NT.
7.1.1 Boot from Diskette:
1. Insert the Microsoft Windows NT Setup Diskette for CD-ROM installation into drive A:
and boot from this disk.
Note: If you do not have the Windows NT Setup diskettes, you can create them from the
Windows NT CD-ROM:
a) First, prepare three blank formatted 3.5" floppy diskettes. Boot your system in DOS.
b) Change to the CD-ROM drive.
c) Then change to the i386 directory.
d) Type: WINNT /OX
This will generate three setup diskettes for Windows NT.
2. The first screen of the NT setup program will show: “Welcome to Setup..." Press
"ENTER" to continue.
3. The next screen will show: "Windows NT provides two Setup methods ....." Press "C"
to run the custom setup.
To Next Page
Loading...
