Tekram Technology DC-395U - NT Driver Management

7. WINDOWS NT DRIVERS7. WINDOWS NT DRIVERS
DC-395 Series User’s Manual
4646
7.2.2 For NT Versions 4.x
1. Boot NT.
2. In Control Panel, double click the "SCSI Adapters" icon.
3. Click on the "Drivers" Tab.
4. Click the "ADD" button.
5. Select "Have Disk".
6. Insert the DC-395 Driver Disk in drive A: and type in the path: \WINNT\3_51-4_x
7. Windows NT will show: "Tekram DC-395U/UW/F or DC-315/U PCI SCSI Adapter
Ver. XXX". Select "OK"
At this point, if the specified driver has already been installed, NT will display the
following message: “The drivers for this adapter are already on the system"
Select "Current" if you want to use existing driver, or select "New" if you want to
replace or upgrade the current driver then enter in the path to the driver files:
A:\WINNT\3_51-4_x
8. Restart the system.
7.3 Removing the SCSI Host Adapter from the System
7.3.1 For NT Versions 3.5x
1. From the Main Program group, double click the Windows NT Setup icon.
2. From the "Option" pull-down menu, select "Add/Remove SCSI Adapters".
3. Select the specific SCSI adapter you want to remove.
4. Click the Remove button to delete the adapter.
7.3.2 For NT Versions 4.x
1. In Control Panel, double click the "SCSI Adapters" Icon.
2. Click on the "Drivers" Tab.
3. Select the driver you wish to remove and click "Remove".-------------
4. Select Yes to remove the driver.