8. WINDOWS 95/98 DRIVERS
DC-395 Series User’s Manual
4848
8.1.2 New Windows 95 OSR2
The driver installation procedures are slightly different for the new Windows 95 “B” (OSR2).
The Windows 95 version is indicated under Control Panel – System.
1. Start the Windows 95/98 Setup according to the Microsoft instructions.
2. Open the Control Panel, and Double-click on the System icon.
3. Click on the "Device Manager" tab and double-click "Other Devices' button.
4. Select the "PCI Bus Controller" entry. Click the "Properties" button.
5. Click the "Driver" Tab. Choose "Update Driver" button
6. "Update Device Driver Wizard" starts and provides several windows with choice,
Follow the steps below to correctly install the device driver for windows 95.
7. After the Introduction window appears, Select "Yes (Recommended) ..".
8. Click "Next" and Insert the Tekram Driver diskette in drive A.
9. Click "Other Locations" and specify the path as A:\Win95_98
10. Update Device Driver Wizard dialog box shows "Windows found the following update
driver for the device : Tekram DC-395U/UW/F or DC-315/U PCI SCSI Adapter. Click
"Finish".
11. A" Copying Files screen" dialog box appears, Specify path as A:\Win95_98 and click
"OK".
12. A "System Settings Change" dialog box appears. Remove the driver disk from the drive
and click on the "Yes" choice to restart the computer.
8.1.3 New Windows 98
Windows 98 will detect the DC-395 series PCI SCSI Adapter as an AMD or Symbios PCI
SCSI Controller and install its built-in driver during Windows 98 Setup. To replace the driver
with the Tekram driver, follow these steps:
1. Start the Windows 98 Setup according to the Microsoft instructions.
2. Open the Control Panel and double-click the System Icon.
3. Click the "Device Manager" Tab.
4. Select "PCI SCSI Bus Controller" entry and click "Properties".
5. Click the "Driver" Tab and choose "Update Driver".
To Next Page
Loading...
