TM 11-6625-2735-14-1
TABLE 5-1 (cont)
Minimum
Description Specifications
Usage
Examples
9. Adapter
Connectors, GR874 to BNC
Trigger checks.
a. Tektronix Part Number
Female.
017-0063-00.
10. Adapter Connectors, GR874 to BNC
Used in Trigger System
a. Tektronix Part Number
Male.
procedure for signal intercon-
017-0064-00.
nection.
11, Elbow Adapter
Connectors, BNC Male to
Used in Trigger System pro- a. Tektronix Part Number
BNC Female.
cedure for signal intercon-
103-0031-00.
nection.
12. T-Connector Connectors, BNC Used throughout procedure
a. Tektronix Part Number
for signal interconnection.
103-0030-00.
13. 10X Attenuator
Ratio, 10X; impedance, 50
Vertical bandwidth check.
a. Tektronix Part Number
ohms; connectors, BNC
Trigger checks.
011-0059-02
14. 5X Attenuator
Ratio, 5X; impedance, 50
Trigger checks.
a. Tektronix Part Number
ohms; connectors, BNC
011-0060-02
15. Termination Impedance, 50 ohms; con-
Used throughout procedure a. Tektronix Part Number
(2 required) nectors, BNC. for proper signal termination.
011-0049-01.
16. 10X Probe
Scale-factor switching; con-
Scale factor check. Cali-
a. Tektronix P6075 Probe
nector, ENC.
brator check.
(supplied with 475 oscil-
loscope).
b. Tektronix P6065 Probe.
17. 500 MHz Filter
Impedance, 50 ohms; fre- Used for High-Speed Timing a Tektronix 500 MHz Filter
quency, adjustable; con-
checks.
calibration fixture, Part
nectors, BNC.
Number 067-0684-00.
18. Screwdriver
Length, three-inch shaft; bit
Used to adjust TRACE a. Xcelite R-3323.
size, 3/32 inch.
ROTATION, ASTIG, GAIN.
OUTLINE FOR PERFORMANCE CHECK
DISPLAY AND VERTICAL SYSTEM CHECK
5. Check ADD Mode Operation
1. Check Display Controls
Page 5-5
6. Check ALT Mode Operation
2. Check Vertical Input Functions
3. Check CH 1 and CH 2 Gain
5-6
5-6
7. Check CHOP Mode Operation
8. Check Vertical Amplifier Bandwidth
9 Check Bandwidth Limit Operation
4. Check CH 2 and CH 1 VAR VOLTS/DIV
Range
5-7
10. Check Cascaded Bandwidth
Page 5-7
5-7
5-8
5-8
5-8
5-8
5-3
To Next Page
Loading...
Need help?
General
