TM 11-6625-2735-14-1
APPENDIX B
COMPONENTS OF END ITEM LIST AND BASIC ISSUE ITEMS LISTS
Section I. INTRODUCTION
B-1. SCOPE
This appendix lists integral components of and basic issue
items for Oscilloscope 0S-261B(V)1/U and 03-261C(V)1/U
to help you inventory items required for safe and efficient
operation.
B-2. GENERAL
This Components of End Item List is divided into the
following sections:
a. Section II. Integral Components of the End Item.
These items, when assembled, comprise the oscilloscope
and must accompany it whenever it is transferred or turned
in. The illustrations will help you identify these items.
b. Section III. Basic Issue Items.
These are the minimum
essential items required to place the oscilloscope in opera-
tion, to operate it, and to perform emergency repairs.
Although shipped separately packaged, BII must be with
the oscilloscope during operation and whenever it is trans-
ferred between property accounts. The illustrations will
assist you with hard-to-identify items. This manual is your
authority to request/requisition replacement BII, based on
TOE/MTOE authorization of the end item.
B-3. EXPLANATION OF COLUMNS
a Illustration. This column is divided as follows:
(1) Figure Number. Indicates the figure number of
the illustration on which the item is shown.
(2) Item Number. The number used to identify
item called out in the illustration.
b. National Stock Number. Indicates the National
stock number assigned to the item and which will be used
for requisitioning.
c. Part Number. Indicates the primary number used by
the manufacturer, which controls the design and character-
istics of the item by means of its engineering drawings,
specifications,
standards, and inspection requirements
to identify an item or range of items.
d. Description. Indicates the Federal item name and,
if required, a minimum description to identify the item.
e. Location. The physical location of each item listed
is given in this column. The lists are designed to inventory
all items in one area of the major item before moving on
to an adjacent area.
f. Quantity Required (Qty Reqd). This column lists the
quantity of each item required for a complete major item.
g. Quantity. This column is left blank for use during an
inventory. Under the Rcvd column, list the quantity you
actually receive on your major item. The Date column is
for your use when you inventory the major item at a later
date; such as for shipment to another site.
Change 1 B-1
To Next Page
Loading...
Need help?
General
