Getting Acquainted with Your Instrument
28 AFG3000 Series Quick Start User Manual
Select Run Mode
Push one of the four Run Mode buttons to select the instrument signal output method.
1. The default Run Mode is Continuous.
To change waveform parameters, see
page 29.
2. To select a modulated waveform, push
the Modulation button.
See page 42 for details on modulating
waveforms.
3. To select a sweep waveform, push the
Sweep button.
See page 40 for details on sweeping
waveforms.
4. To select a burst waveform, push the
Burst button.
See page 38 for details on Burst mode.
1
2
3
4
To Next Page
Loading...
