Tektronix AFG3000 Series - Adjust Waveform Parameters

Getting Acquainted with Your Instrument
AFG3000 Series Quick Start User Manual
29
Adjust Waveform Parameters
When you turn on your instrument, the default output signal is a 1 MHz sine waveform with an amplitude of 1 V
p-p
. In the
following example, you can change the frequency and amplitude of the original output signal.
1. Push the front-panel Default button to
display the default output signal.
2. To change frequency, push the
front-panel Frequency/Period short-
cut button.
3. Frequency is now active. You can
change the value using the keypad and
Units bezel menu, or you can change
the value with the general purpose
knob.
4. Push the Frequency/Period shortcut
button again to toggle the parameter to
Period.
5. Next, change amplitude. Push the
Amplitude/High shortcut button.
6. Amplitude is now active. You can
change the value using the keypad and
Units bezel menu, or you can change
the value using the general purpose
knob.
7. Push the Amplitude/High shortcut
button again to toggle the parameter to
High Level.
You can change the values of Phase
and Offset in the same way.
1
2
3
4
5
6
7