Operating Basics
AFG3000 Series Quick Start User Manual
39
To Generate a Gated Burst Waveform
In the gated burst mode, the output is enabled or disabled based on the internal gate signal or an external signal applied
to the front-panel Trigger Input connector. While the gate signal is true or the front-panel Manual Trigger button is
depressed, the instrument outputs a continuous waveform.
Quick Tips
■ The instrument provides the following three trigger sources for Burst mode:
■ Internal or external trigger signal
■ Manual trigger
■ Remote command
■ Once Gate is selected, burst count parameters are ignored.
1. Push the front-panel Burst button to
display the burst menu.
2. Select Gate.
3. This is a sample oscilloscope screen.
The top waveform is an external trigger
signal.
4. This is a gated waveform sample.
2
1
3
4
To Next Page
Loading...
