Tektronix Keithley 2601B-PULSE - Section 3 Instrument Description; Front Panel Controls, Indicators, and Connectors

In this section:
Controls, indicators, and connectors ........................................ 3-1
Menu overview ......................................................................... 3-7
Beeper ................................................................................... 3-14
Displayed error and status messages .................................... 3-14
Display operations .................................................................. 3-15
Connecting the USB flash drive ............................................. 3-27
Restoring the factory default setups using remote commands3-28
Using the web interface .......................................................... 3-28
Controls, indicators, and connectors
2601B-PULSE controls, indicators, and the USB port are on the front panel (on page 3-1). Make
connections to the 2601B-PULSE through connectors on the rear panel (on page 3-5).
Front panel
The front panel of the 2601B-PULSE is shown below. The descriptions of the front-panel controls,
USB port, and indicators follow the figure.
Figure 28: 2601B-PULSE front-panel controls
1. Power switch, display, and configuration keys
Toggles between the source-measure or pulser display and the user message display.
Configures a function or operation.
Power switch. The in position turns the 2601B-PULSE on (I); the out position turns it
off (O).
Section 3
Instrument description