Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Examples
ACQUIRE:STOPA
FTER RUnsTOP
sets the oscilloscope to continually acquire data.
ACQUIRE:STOPAFTER? might return:ACQUIRE :STOPAFTER SEQUENCE
indicating th
at the next acquisition the oscilloscope makes will be of the
single-sequence type.
ACTONEVent:ACTION:AUXOUT:STATE
Sends a pulse to the Auxiliary Out port when a specified event occurs, or queries
the state of the “pulse to aux out” action. The default state is 0 (off).
To specify an event, use the command ACTONEVent:EVENTTYPe.
Group
Act on Event
Syntax
ACTONEVent:ACTION:AUXOUT:STATE <0|1|OFF|ON>
ACTONEVent:ACTION:AUXOUT:STATE?
Arguments
1, ON sends a pulse to the Auxiliary Out port when the specified event occurs.
0, OFF turns off this action.
Examples
ACTONEVENT:ACTION:AUXOUT:STATE ON specifies to send a pulse to the
Auxiliary Out port when the specified event occurs.
ACTONEVent:ACTION:EMAIL:SETUp:TOADDRess
Sets (or queries) the email address for the recipient when the
ACTONEVent:ACTION:EMAIL:STATE command is used.
To set up the email address for the sender, use EMAIL:SETUp:FROMADDRess.
Group
Act on Event
Syntax
ACTONEVent:ACTION:EMAIL:SETUp:TOADDRes s <QString>
ACTONEVent:ACTION:EMAIL:SETUp:TOADDRes s?
Arguments
Quoted string that represents the recipient’s email address. The maximum number
of characters allowed is 128.
2-118 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English