Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Arguments
1, ON stops acqu
isitions when the specified event occurs.
0, OFF turns off this action.
Examples
ACTONEVENT:ACTION:STOPACQ:STATE ON specifies to stop acquisitions when
the specified event occurs.
ACTONEVent:ACTION:VISUAL:STATE
Displays a visual notification when a specified event occurs, or queries the state of
the “display a visual notification” action. The default state is 0 (off).
To specify an event, use the command ACTONEVent:EVENTTYPe.
Group
Act on Event
Syntax
ACTONEVent:ACTION:VISUAL:STATE <0|1|OFF|ON>
ACTONEVent:ACTION:VISUAL:STATE?
Arguments
1, ON displays a visual notification when the specified event occurs.
0, OFF turns off this action.
Examples
ACTONEVENT:ACTION:VISUAL:STATE ON specifies to display a visual
notification when the specified event occurs.
ACTONEVent:EVENTTYPe
Specifies (or queries) which event to act on (TRIGger, ACQCOMPLete, or
NONe) when using an Act on Event command. The default is
NONe.
To specify the action to take, use the
ACTONEVent:ACTION commands.
Group
Act on Event
Syntax
ACTONEVent:EVENTTYPe <NONe|TRIGger|ACQCOMPLete>
ACTONEVent:EVENTTYPe?
Arguments
NONe no event (this is the default).
TRIGger specifies to act when a trigger occurs.
2-122 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English