Commands Listed in Alphabetical Order
Conditions
This command re
quires installation of a DPO4AERO application module for
MDO4000C models, or MDO3AERO for MDO3000 models.
Group
Bus
Syntax
BUS:B<x>:ARINC429A:SOUrce
{CH1|CH2|CH3|CH4|MATH|REF1|REF2|REF3|R EF4}
BUS:B<x>:ARINC429A:SOUrce?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:CONDition
BUS:B<x>:ARINC429A:SOUrce
Arguments
CH1-4 specifies an analog channel as the source for the differential input.
MATH specifies the math waveform as the source for differential input.
REF1-4 specifies a reference waveform as the source for differential input.
Examples
BUS:B1:ARINC429A:SOUrce REF4 specifies to use the reference waveform 4
as the source.
BUS:B1:ARINC429A:SOUrce? might return CH2, indicating that channel 2 is
the currently specified source.
BU
S:B<x>:AUDio:BITDelay
Specifies the number of delay bits for the AUDIO bus.
NOTE. This command is applicable only for TDM audio bus type
(
BUS:B<x>AU Dio:TYPe TDM
)
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
Syntax
BUS:B<x>:AUDio:BITDelay <NR1>
BUS:B<x>:AUDio:BITDelay?
Arguments
<NR1> specifies the number of delay bits.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-159
To Next Page
Loading...
Need help?
General
