Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Group
Bus
Syntax
BUS:B<x>:ETHERnet:PRObe {DIFFerential|SINGleended}
BUS:B<x>:ETHERnet:PRObe?
Related Commands
BUS:B<x>:ETHERnet:SOUrce:DIFFerential
BUS:B<x>:ETHERnet:SOUrce:DMINus
BUS:B<x>:ETHERnet:SOUrce:DPLUs
Arguments
DIFFerential
SINGleended
Examples
BUS:B1:ETHERnet:PRObe DIFFerential specifies that
a differential probe is connected to the input channels
specified by
BUS:B<x>:ETHERnet:SOUrce:DPLUs and
BUS:B<x>:ETHERnet:SOUrce:DMINus.
BUS:B1:ETHERnet:PRObe?
might return SINGLEENDED, indicating that the
probe type has been set to single-ended.
BUS:B<x>:ETHERnet:PROTOcol
Use this command to set the Ethernet protocol type to TCP/IPv4, or to OTHER.
The default is IPV4.
NOTE. The commands TRIGger:A:BUS:B<x>:ETHERnet:CONDition DATa and
SEARCH:SEARCH<x
>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition DATa
are impacted by the setting of this command.
Conditions
This command req
uires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Bus
Syntax
BUS:B<x>:ETHERnet:PROTOcol {IPv4|OTHER}
BUS:B<x>:ETHERnet:PROTOcol?
Related Commands
TRIGger:A:BUS:B<x>:ETHERnet:CONDition
2-174 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English