Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
Arguments
IPv4 sets the E
thernet protocol type to Internet Protocol version 4.
OTHER sets the Ethernet protocol type to other than IPv4.
Examples
BUS:B1:ETHERnet:PROTOcol IPv4 specifies IPv4 as the Ethernet protocol.
BUS:B1:ETHERnet:PROTOcol? might return OTHER.
BUS:B<x>:ETHERnet:SOUrce:DIFFerential
This command specifies the Ethernet data source for differential input. The
supported source waveforms are channels 1–4, math waveform, and reference
waveforms 1–4. The default is channel 1.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Bus
Syntax
BUS:B<x>:ETHERnet:SOUrce:DIFFerential {CH1|CH2|CH3| CH4|MATH
|REF1|REF2|REF3|REF4}
BUS:B<x>:ETHERnet:SOUrce:DIFFerential?
Related Commands
BUS:B<x>:ETHERnet:PRObe
TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
Arguments
CH1–4 specifies to use one of the channels 1–4 as the Ethernet data source for
differential input
.
MATH specifies to use the math waveform as the source for Ethernet data
differential inpu
t
REF1–4 specifies to use one of the reference waveforms 1–4 as the source for
Ethernet data dif
ferential input.
Examples
BUS:B1:ETHERnet:SOUrce:DIFFerential ref4 specifies to use reference
waveform 4 as the source for the Ethernet data differential input.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-175

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English