Commands Listed in Alphabetical Order
Syntax
BUS:B<x>:RS23
2C:RX:SOUrce {CH1|CH2|CH3|CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15|Off}
BUS:B<x>:RS2
32C:RX:SOUrce?
Arguments
CH1–CH4 specifies an analog channel as the RX source waveform.
D0-D15 specifies a digital channel as the RX source waveform.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
Off sets the specified bus input to off.
BUS:B<x>:RS232C:TX:SOUrce
This command specifies the TX source waveform for the RS-232 bus.
Conditions
This command requires a DPO4COMP application module for 4000 series
models, and an MDO3COMP application module for MDO3000 series models.
Group
Bus
Syntax
BUS:B<x>:RS232C:TX:SOUrce {CH1|CH2|CH3|CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15|Off}
BUS:B<x>:RS232C:TX:SOUrce?
Arguments
CH1–CH4 specifies an analog channel as the TX source waveform.
D0-D15 specifies a digital channel as the TX source waveform.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
Off sets the specified bus input to off.
BUS:B<x>:SPI:BITOrder
This command specifies the bit order for the SPI bus. LSB is least significant bit
first; MSB is most significant bit first.
Conditions
This command requires a DPO4EMBD application module for 4000 series
models, and an MDO3EMBD application module for MDO3000 series models.
2-194 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
