Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
HARDCopy:PRIN
Ter:REName "labprn1", "labprn2",
"newserver.example.com", ""
HARDCopy:PRI
NTer:REName 1, "lab prn2",
"newserver.example.com", ""
Email print
er:
If the first entry on the printer list is for a network printer called 'labprn1', either
of the follo
wing commands could be used to replace this printer with an email
printer 'emailPrinter@example.com':
HARDCopy:
PRINTer:REName "labprn1", "labprn3@example.com"
HARDCopy:PRINTer:REName 1, "labprn3@example.com"
If the first entry on the printer list is for an email printer whose email address is
'oldEmail@example.com', either of the following commands could be used to
replace
this printer with an email printer 'newEmail@example.com':
HARDCopy:PRINTer:REName "oldEmail@example.com",
"newEm
ail@example.com"
HARDCopy:PRINTer:REName 1, "newEmail@example.com"
HEADer|:HDR
This command specifies the Response Header Enable State that causes the
oscilloscope to either include or omit headers on query responses.
NOTE. This command does not affect IEEE Std 488.2-1987 Common Commands
(those starting with an asterisk); these commands never return headers. This
command does affect the Response Header Enable State of both the USBTMC and
VX
I-11 interfaces. Refer to the Introduction for additional information.
NOTE. Refer to the Waveform Transfer Command Group text for more
c
omprehensive information.
Group
Miscellaneous
Syntax
HEADer|:HDR {OFF|ON|<NR1>}
HEADer|:HDR?
Related Commands
VERBose
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-337

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English