Commands Listed in Alphabetical Order
VERBose
This command specifies the Verbose state that controls the length of keywords on
query responses. Keywords can be both headers and arguments.
NOTE. This command does not affect IEEE Std 488.2-1987 Common Commands
(those starting with an asterisk). This command does affect the v erbose state
of both the U
SBTMC and VXI-11 interfaces. Refer to the Introduction for
information.
Group
Miscella
neous
Syntax
VERBose {OFF|ON|<NR1>}
Related Commands
HEADer|:HDR,
*LRN?,
SET?
Arguments
OFF sets the Verbose state to false, which returns minimum-length keywords
for applicable setting queries.
ON sets the Verbose state to true, which returns full-length keywords for applicable
setting queries.
<NR1> a 0 returns minimum-length keywords for applicable setting queries; any
other value returns full-length keywords.
Examples
VERBOSE ON enables the Verbose state.
VERBOSE ? might return :VERB 0 indicating that the Verbose state is disabled.
VIDPic:AUTOContrast
Sets (or queries) the video picture automatic contrast state.
Automatic contrast uses histogram equalization to optimize the use of brightness
levels; each brightness level occupies approximately the same area in the image.
Conditions
MDO3000 series. Requires option SA3 or SA6 for the MDO4000C series.
Requires the DPO4VID application module for use with MSO/DPO4000B,
MDO4000 and MDO4000B mod
els.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-935
To Next Page
Loading...
Need help?
General
