Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4LMT application module for 4000 series models,
and an MDO3LMT application module for MDO3000 series models.
Group
Mask
Syntax
MASK:TESt:SAVEWFM {ON|OFF|<NR1>}
MASK:TESt:SAVEWFM?
Related Commands
MASK:TESt:STATE,
FILESystem:MKDir
Arguments
ON turns on this feature, so that waveform data from all active channels is copied
to files upon test failure.
OFF turns off this feature.
<NR1> is an integer. 0 turns off this feature; any other value turns it on.
Examples
MASK:TEST:SAVEWFM ON sets the instrument to save the failing waveform data
to a file.
MASK:TESt:SRQ:COMPLetion
This command causes the instrument to send an SRQ command when a pass/fail
mask test completes. Use the command MASK:TESt:COMPLetion:CRITerion to
specify criterion.
A series of examples showing how to use mask commands for t
ypical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
NOTE. NOTE: SRQ generation requires that the SRER ESB bit is 1 (*SRE 32)
and the ESER OPC bit is 1 (*ESE 1).
Conditions
This command requires a DPO4LMT application module for 4000 series models,
and an MDO3LMT application module for MDO3000 series models.
Group
Mask
Syntax
MASK:TESt:SRQ:COMPLetion {ON|OFF|<NR1>}
MASK:TESt:SRQ:COMPLetion?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-391
To Next Page
Loading...
