Commands Listed in Alphabetical Order
Syntax
MASK:USER{:SE
G<x>|:MASK<x>}:NR_Pt?
Related Commands
MASK:CUSTom,
SAVe:MASK
Returns
Integer
Examples
MASK:USER:SEG3:NR_Pt? might return 0, indicating that there is no segment
3 in the current mask.
MASK:USER{:SEG<x>|:MASK<x>}:POINTS
This command specifies the x and y coordinates of the points that make up the
segment 1–8. The units are normal wave
form units. The x-coordinate is specified
relative to the trigger. The points are specified as a sequence of (x,y) points which
traverse the boundary of the segment in a counter-clockwise direction.
A series of examples showing how to use mask commands for typical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
Conditions
This command requires a DPO4LMT application module for 4000 series models,
and an MDO3LMT application module for MDO3000 series models.
Group
Mask
Syntax
MASK:USER{:SEG<x>|:MASK<x>}:POINTS <NR3>
MASK:USER{:SEG<x>|:MASK<x>}:POINTS?
Related Commands
MASK:CUSTom,
SAVe:MASK
Arguments
<NR3> is a floating- point number.
Examples
:MASK:USER:SEG1:POINTS -20e-6,.1,20e-6,.1,20e-6,.2,-20e-6,.2
:MASK:USER:SEG2:POINTS -20e-6,-.2,20e-6,-.2,20e-6,-.1,-20e-6,-.1
2-402 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
