Commands Listed in Alphabetical Order
Syntax
MEASUrement:M
EAS<x>:STATE {OFF|ON|<NR1>}
MEASUrement:MEAS<x>:STATE?
Related Commands
MEASUrement:
MEAS<x>:SOUrce<x>,
MEASUrement:MEAS<x>:TYPe
Arguments
OFF disables calculation and display of the specified measurement slot.
ON enables calculation and display of the specified measurement slot.
<NR1> = 0 disables calculation and display of the specified measurement slot; any
other value enables calculation and display of the specified measurement slot.
Examples
MEASUREMENT:MEAS2:STATE ON computes and displays the measurement
defined as measurement 2.
MEASUREMENT:MEAS1:STATE? might return :MEASUREMENT:MEAS1:STATE 0
indicating that measurement defined for measurement slot 1 is disabled.
MEASUrement:MEAS<x>:STDdev? (Query Only)
Returns the standard deviation of values accumulated for this measurementsince
the last statistical reset. Measurements are specified by <x>, the measurement
slots, from 1 through 8.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:STDdev?
Examples
MEASUREMENT:MEAS1:STDDEV? might return :MEASUREMENT:MEAS1:STDDEV
21.0E-12.
MEASUrement:MEAS<x>:TYPe
This command specifies the measurement type defined for the specified
measurement slot. The measurement slotisspecifiedby<x>,whichrangesfrom
1 through 8 in all models except MDO3000, which only support 4 simultaneous
measurements.
Digital channel measurements do not have a user-settable midRef threshold. If
you specify a digital channel measurement that is not available, measurement
error 2200: measurement system error occurs and 9.9e37 is returned.
2-438 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
